Function Description
① This temperature controller has soft start mode, manual mode and automatic mode functions. The soft start mode is the preheating and dehumidification function, which will not damage the heater due to mold moisture, thus extending the service life of the hot runner.
② Thermocouple type J or K is adjustable; temperature unit ℃ or ℉ is adjustable and displayed in PV window. Temperature setting range: 34-534℃
③ Input voltage: 220VAC±10% 50—60Hz or 110VAC±10% 50—60Hz, optional.
④ Multiple alarm and protection functions: low temperature alarm, high temperature alarm, temperature sensing wire disconnection alarm, temperature sensing wire reverse connection alarm, hot runner leakage protection alarm.
Technical Parameter Table Function Parameter Setting Table
Item | Code | Description | Factory Setting | ||
Input Voltage | 85V—250VAC | P01 | Temperature unit setting: can be set to ℃ or ℉ and displayed in SV display window | Factory set to ℃ | |
Input Frequency | 50—60HZ | ||||
Operating Temperature | -10℃—55℃ | P02 | Alarm on/off setting: set to ON to activate the alarm function, set to OFF to cancel the alarm function | Factory set to ON | |
Storage Temperature | -20℃—70℃ | ||||
Fuse Specification | 15A 250V ø6mm×30mm, 1‰sec | P03 | Control mode selection: PID control mode or F2y control mode | Factory set to PID mode | |
Temperature Sensing Wire Type (Thermocouple Type) | K, J | ||||
Temperature Setting Range | 40℃—540℃ | P04 | Low temperature time setting: setting range 0—255S | Factory set to 240S | |
Sampling Speed | 0.1S | ||||
Temperature Measurement Accuracy | ±0.1℃ | P05 | High temperature time setting: setting range 0—80S | Factory set to 15S | |
Temperature Control Accuracy | ±1℃ | ||||
Output Voltage | 0—220V | P06 | Sensor type selection: K type or J type adjustable | Set according to customer's requirements | |
Maximum Output Power | 3.6KW | ||||
Temperature Unit | ℃、℉ | P07 | Key on or lock selection: "uLc" means key is on and can be used; "Loc" means key is locked and cannot be used | Factory set to "uLc" |
