200℃ 水温机
200℃ water temperature machine
Characteristics
1、This device is a extremely simplified CTA integrated with heating unit, media circulating device and control panel, which reduces installation area and saves space.
2、 It can handle a great heat load produced by mold due to adopting direct cooling way.
3、 The adoption of water pump with high pressure and mass flow makes small part of mold waterway obtained a larger flow and can evenly control the temperature of mold.
4、All pipes and fittings are SUS304 stainless steel, and all interfaces are sealed by high temperature sealant of good sealing performance and long service life.
5、The thermal media of this mold temperature machine is water, and the maximum control temperature is 200℃.
6、The control part makes full use of the microcomputer, equipped with the latest special controller with the function of appointment start, stop operation and alarm.
The machine adopts PID control mode, non-contact SSR solid-state relay power supply heating is of high-precision temperature control and long service life, and the temperature setting and display value is digital. In addition, a standard timer runs (99.59 hours). Substrate is of remote control start and stop input contacts and integrated alarm output contacts.
7、The main power switch of this device has a linkage function, that is, when the temperature rise of the mold temperature controller exceeds 210℃, the main switch will receive a signal and the automatic trip will be disconnected.
8、This device has high voltage protection to prevent explosion due to high internal pressure.
Alarm protection function：
1、 Reverse-phase alarm
2、 Insufficient media(water) alarm
3、 Over-load alarm
4、 Over-temperature alarm and power-off protection
5、Low temperature alarm
6、High temperature protection
Technical parameter table
Type
Project
YK-HW180-12KW
YK-HW180-24KW
Media using temperature
Water
Maximum temperature
200℃
Controlling method
PID Control
Heater
Capacity（kw）
12
24
Controlling method
SSR Control
Media pump
Sealing method
Without shaft seal
Motor power（HW/50Hz
1.1
3
Maximum pressure（MPa）
0.57
0.78
Maximum flow（L/min）
55
128
Full field（m）
57
78
Booster pump
Type
Magnetic plunger pump
Motor power（KW/50Hz）
0.048
Maximum pressure（MPa）
1.5
Maximum flow（L/min）
0.65
Cooling method
Direct cooling
Cooing capacity（KW×）△t=30℃）
7.3
Piping diameter
Circulatory system
3/8（10A）×4 circuit
3/8（10A）×4 circuit
Cooling system
4cent（15A）
6cent（20A）
Alarm
Reverse-phase，Insufficient media，pump overload，Temperature limit，overheat protection
Public project
Power supply
AC 200V/60Hz 380V/50Hz 4150V/50Hz 3P+E(5m) (can be ordered according to the industrial power supply in the area)
Main air-opening capacity
20/32
32/40
Total electrical capacity（KW）(50Hz)
7.05
10.05
Cooling water（L/min）
15
Cooling water pressure（MPa）
0.2-0.5
Dimension L×W×H
630*250*720
790*320*850
Weight（Kg）
75
110
The above is a standing model, which can be ordered according to customers’ demand.
